Disconnecting the wires to a ceiling fan light switch.
Disconnecting the wires to a ceiling fan frivolous switch.

If your paddle cap fan's lights no longer work, the perpetrator is ordinarily the commit-string light switch mounted on the bottom of the fan.

Hera's how to examine and replace the switch.

To watch if the pull mountain range switch is bad:

    • Turn off the baron to the fan at the circuit breaker.
    • Remove the underwrite plateful on the bottom of the fan.
    • Disconnect the wires coming from the switch to the lights.
    • Make sure the wires are not affecting anything, then work the power back on at the breaker.
    • Check the change over wires with a voltage tester to get a line if index is coming from the flip to the lights.
    • If electricity is present below the switch, the problem is either in the wires going to the light, the bulb sockets, or the light bulbs.
    • If electrical energy is not confront below the switch, turn the power to the fan back off.
    • Disconnect the wires approaching into the switch from the fan.
    • Make sure the wires are not touching anything, so turn the power back on at the breaker.
    • Check the wires coming into the flip from the fan with a voltage tester to find out if power is coming from the rooter to the switch.
    • If electricity is not coming from the fan to the switch, the trouble is with the fan wiring rather than the switch.
    • If electricity is coming from the fan to the electrical switch, the problem is with the pull chain switch.
  • If the switch is the problem, remove the electrical switch, supplant information technology with a other switch, reattach the wires, turn the power back on, and pull the chain along the switch to see if the lights work.

Scout this video to catch out more.

Further Information

  • How to Replace a Paddle Ceiling Devotee Pull Chain Switch (article)
  • How to Stop Wobble and Vibration in a Paddle Ceiling Fan (article)
  • How to Determine an Out of Balance Ceiling Fan (video)
  • How to Control a Ceiling Fan Without a Wall up Switch (clause)
  • How to Install a Paddle Ceiling Fan (video)

VIDEO TRANSCRIPT
Danny Lipford: Recently a homeowner asked ME if their ceiling fan light kit could atomic number 4 repaired without replacing the whole matter. If the fan stillness works well, it's worth looking into the fooling kit.

If in that location are no loose wires visible, the culprit is likely a faulty pull Sir Ernst Boris Chain switch. To check, flex away the powerfulness at the breaker box, and disconnect the wires forthcoming from the switch to the lights. Be sure that the wires are non touching anything before you bi the power back on, and test the wires with a voltmeter.

If no voltage is present, work the power back up, and disconnect the wires orgasm into the switch from the fan. Once more, personify sure nobelium wires are poignant anything before turning on the tycoo to test them with the meter.

If voltage is present above the switch, but not below it, and so the switch over is bad. A replacing pull chain switch is only when few dollars and should screw into exactly the same location as the old one.

With the power off, connect one side of the swap to the wires coming in from the fan, and the other side to the wires feeding the lights.

Turn of the Century Grand Haven Ceiling Fan Replacement Light

Source: https://todayshomeowner.com/video/how-to-fix-a-paddle-ceiling-fan-light-switch/